Enter your Email address powermax 30 air pdf and press the GO button. Hypertherm has discontinued the printed version of this manual. 8204 Pulaski Hwy, Baltimore, MD 21237 Please call us at 410-687-8400 to speak to a sales representative. Our Customer Service Department hours are 07:30 to 05:00 E.
Enter your Email address below and press the GO button. 8204 Pulaski Hwy, Baltimore, MD 21237 Please call us at 410-687-8400 to speak to a sales representative. Our Customer Service Department hours are 07:30 to 05:00 E. Hypertherm POWERMAX 45 Operator’s Manual Plasma arc cutting system. Page 2 Register your new Hypertherm system Register your product online at www. You can also receive updates on new Hypertherm products and a free gift as a token of our appreciation.
All Rights Reserved Hypertherm and powermax are trademarks of Hypertherm, Inc. 55 11 2408 0462 Fax 82 Genting Lane Media Centre Hypertherm México, S. MC-1 WARRANTy W-1 SeCTION 1 SPeCIfICATIONS System description 1-2 Where to find information . 1-2 Power supply dimensions and weights 1-3 Dimensions 1-3 Weights .
1-3 Power supply ratings 1-4 T45v torch dimensions . 1-5 T45m torch dimensions 1-5 T45v and T45m torch specifications 1-6 Symbols and marks 1-7 IEC symbols . 2-6 Connect the gas supply 2-7 Additional gas filtration . 2-7 SeCTION 3 TORCH SeTUP Introduction .
3-2 Hand torch setup 3-2 Choose the consumables . 3-8 Using the cut charts . 4-12 Ensure the torch and table are set up correctly 4-12 Understand and optimize cut quality . 4-13 To pierce a workpiece using the machine torch 4-14 Common machine-cutting faults . 4-15 SeCTION 5 MAINTeNANCe ANd RePAIR Perform routine maintenance . Hypertherm’s CE-marked equipment is built in compliance cutting equipment. The equipment should be installed and used in accordance with the information b.
Page 12: Electromagnetic Compatibility, Maintenance Of Cutting Equipment ELECTROMAGNETIC COMPATIBILITY earthing of the workpiece Consideration should be given to shielding the supply cable of permanently installed cutting equipment, Where the workpiece is not bonded to earth for in metallic conduit or equivalent. Page 14: Patent Indemnity Products exceed in the aggregate the amount the use of the Hypertherm product, alone and not in paid for the Products that gave rise to such claim. Hypertherm, infringes any patent of any third party. Page 15 Section 1 SPeCIfICATIONS In this section: System description 1-2 Where to find information . Page 16: System Description Operator Manual, a Quick Setup Card, and a Setup DVD. Mechanized configurations include a remote-start pendant as well. See the Parts section for a list of spare and optional parts.
Page 17: Power Supply Dimensions And Weights SpecificationS Power supply dimensions and weights dimensions 34. Weights Power supply weights given below include the hand torch with 6. Page 19: T45v Torch Dimensions SpecificationS T45v torch dimensions 22. Page 21: Symbols And Marks Symbols and marks Your Hypertherm product may have one or more of the following markings on or near the data plate. Due to differences and conflicts in national regulations, not all marks are applied to every version of a product. Page 22: Iec Symbols SpecificationS IeC symbols The following symbols may appear on the power supply data plate, control labels, switches, and LEDs.